• • Mode 9.6 Hz (these specific modes run that frequency entire timer setting until Wake Up Function starts)
  • Mode Schumann @ 7.83 Hz
  • Tesla 1 @ 9.63 Hz
  • Tesla 2 @ 3.69 Hz
  • Mode 14.4 Hz
  • SLEEP 1
  • SLEEP 2
  • SLEEP 3
  • SLEEP 4
  • SLEEP EZ
  • MANUAL Mode
  • RECOVER Mode
  • ALERT Mode
  • ENTRAIN UP
  • ENTRAIN-DOWN

The EarthPulse v6 Sleep on Command has a Wake-Up Buffer of 14.4 Hz at the completion of all these but for Entrain Up and Down.

Device boots to 70% amplitude (roughly v.4 and v5 amplitude); adjust amplitude up / down using arrow buttons during run-time.

Programs are algorithmic so Wake Up Function starts later and later depending upon how short you set the timer. Set any mode for 15 mins or 12 hours. One hour Buffer at 14.4 Hz runs 60 mins no matter what time is set.

Timer defaults to 8 hours for all program modes below.

SLEEP MODES

The Sleep Modes are designed to enable the user to entrain their brain and correct the circadian rhythm while at the same time get deep synergistic sleep and cellular recovery.

They work especially well to help regain circadian rhythm. These finish with the Buffer for 60 minutes at completion.

SLEEP 1

Starts at RECOVER-MODE (ALPHA – 9.6 Hz); after 15 minutes it steps down slowly through THETA to low-DELTA, cycling between 1 Hz and 5 Hz   3 more times during the night; with WAKE UP function and new 1 Hr buffer of 14.4 Hz prior to shut down.

SLEEP 2

Starts at RECOVER -MODE, steps down through THETA to low-DELTA, cycling between 1 and 3 Hz 3 more times during the night; with WAKE- UP phase (RECOVER then ALERT / low-BETA) prior to 1 Hr 14.4 Hz buffer & shut down.

SLEEP 3

Starts at DELTA (3 Hz), cycles to 1 Hz total of 4 times during the night; w/WAKE-UP phase (THETA, RECOVER, ALERT then 14.4 Hz buffer) prior to shut down. Use SLEEP 3 as fall-back setting after waking or and not falling asleep in higher sleep settings like 9.6 Hz.

SLEEP 4

Starts and stays at 1 Hz (DELTA), shifts to 14.4 Hz for 1 hour at end of timer. Start with SLEEP 4 only if your sleep is still terrible in SLEEP-3. Use SLEEP 4 as fall-back setting when waking and not falling back to sleep in SLEEP EZ, SLEEP-2 or SLEEP 3.

SLEEP EZ

Starts at 9.6 Hz at 15 minutes  (on 8 hour time setting)  falls quickly to 3 Hz Delta and cycles in Delta between 3 Hz and 1 Hz three more times until wake up phase during last 20 minutes of programming on an 8 hour setting. 1 hour Buffer runs at 14.4 Hz upon completion of timer to avoid sleeping through the wake up phase.

MANUAL Mode

The Manual Mode Program is capable of delivering the entire range of beneficial PEMF – 0.5 Hz – 14.4 Hz for up to 12 hours. The goal is sleeping in  9.6 Hz every night, though some may never attain this.

With the Manual Mode Program you are free to experiment sleeping / recovering / meditating with any one particular frequency.

It may be one of the Schumann peaks at 1.5 Hz (1.2 Hz?) or 2.5 Hz (2.4 Hz?) or 7.8 Hz, or 9.6 Hz or 10 Hz (or any choice in between .5 and 14.4 Hz). At the end of set timer, the frequency shifts to 14.4 Hz to help awaken. The 1 hour 14.4 Hz buffer effectively becomes the wake up part of the program. Now, v6 Manual Mode is adjustable to 100th or .01 Hz.

For feeling ALERT use Alert Mode 12 – 14.4 Hz. Also studies show shifting introduced frequencies provide better EMF protection so should relate better to wireless protection. Keep in mind our “pulsed” nature means the device is OFF 1/2 the time.

Author finds 2.4 Hz, 4.8 Hz and 9.6 Hz particularly good at recovering during the night and rarely ends up sleeping a full 8 hours without waking on his own long before the timer runs to wake up phase. See our article – Why 9.6 Hz and its amazing harmonic relationship to healing tones, sacred geometry and terrestrial measurements.

RECOVER Mode

RECOVER Mode makes an excellent sleep program if sleep is not too bad to begin with specially if you are an athlete. If you did not attain sleep during initial session use SLEEPEZ or SLEEP-3 and intermittently use RECOVER during power naps to try to acclimate brain to it. Mode 9.6 Hz makes this setting obsolete.

ALERT Mode

(LOW-BETA) reduces physical and mental fatigue; use for recovery issues without causing drowsiness; used at end of RECOVER and SLEEP modes to assist in wake-up; may be used at desk to reduce neck and shoulder fatigue without causing drowsiness. Shifts between 12 Hz and 14.4 Hz and provides the best wireless and EMF protection. Keep in mind the pulsed nature of the EP means it is OFF 1/2 the time. The metal parts in the magnet always have some magnetism but if not pulsing it does not travel.

ENTRAIN-UP and ENTRAIN-DOWN

2 Entrainment modes to help get accustomed to PEMF fields. Entrainment programs (ENTRAIN UP & DOWN) were designed to hit each frequency in the device’ range in 30 minutes to an hour. The timer is limited to one hour.

ENTRAINMENT-UP and ENTRAINMENT-DOWN DO NOT have the 1 hour 14.4 Hz ‘buffer’.

ENTRAIN-UP ends at 14.4 and shuts down. ENTRAIN-DOWN gores back down from 14.4 Hz and shuts down when reaching 1 Hz.

Generally no Dual-Polarity Ring above the neck. Dual polarity ring near head gives the inventor a headache. You can experiment yourself to determine.