1. Product Feature
• 3 working modes: 9.6Hz mode, Alert mode, Tesla mode.
• 9.6Hz mode – Magnet frequency will be 9.6Hz
• Alert mode- Magnet frequency will be 14.4Hz
• Tesla mode – Magnet frequency will be 3.69Hz
• After timer completion of mode 15 mins 14.4Hz (alert) magnet will be ON.
• Mode timer is adjustable.
• After completion LCD displays DONE.
• Power saving by automatically lcd backlight off after 1 minutes of inactivity.
• Small LED blinks with magnet frequency when the module is working.
2. System Identification
3. Procedures
Step 1: Power up the module with recommended power adaptor after connecting all the required
magnets/coils.
Step 2: Ensure the LCD display is ON after pressing power button.
Step 3: Ensure LCD display displays “welcome”, “SleepOn Command”, “9.6Hz mode”.
Step 4: Check if LCD backlight is getting off after 1 minutes (approx.) of no activity. Note down the
time taken for lcd backlight off after inactivity.
Step 5: After LCD light is off, check if LCD backlight is getting ON when up/down is pressed. Ensure
that the LCD display message is same as the message before display OFF.
Step 6: Press UP/Down button and ensure different modes are displayed on the screen.
Step 7: Press Select button and check if the screen is going to timer selection section for the
particular mode selected.
Step 8: Check if LCD backlight is getting off after 1 minutes (approx.) of no activity. Note down the
time taken for lcd backlight off after inactivity.
Step 9: Check if the timer value is changing by pressing UP/Down Button
Step 10: Check if display is displaying the below screen (for corresponding mode selected) after pressing
Select button
Step 11: Monitor LED blinking is ON, time is reducing with 1 minute duration and mode is correct.
Also, check magnet working properly.
Step 12: Check if LCD backlight is getting off after 1 minutes (approx.) of no activity. Note down the
time taken for lcd backlight off after inactivity.
Step 13: Check if LCD displays DONE after completing set timer and extra 15 minutes. Check if LCD
backlight is ON during done message till select button is pressed.
Step 14: After done message, if select button is pressed the screen and system should go to mode
selection page.
Step 15: Repeat above steps for each mode.